Table of Contents
Advertisement
14
www.aeg.com
6.2 Introduction
The options/functions are
not selectable with all
washing programmes. Check
the compatibility between
options/functions and
washing programmes in the
"Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allowed
you to set the incompatible
options/functions together.
6.3 Teplota
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and
heat the water.
6.4 Odstřeďování
When you set a programme, the
appliance automatically selects the
maximum spin speed.
Touch this button repeatedly to:
• Decrease the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics
from creasing. The washing
programme ends with water in the
drum and the final spin phase is not
performed.
The display shows the indicator
The drum turns regularly to reduce
creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
, the appliance does not
Touch Start/Pauza button: the
appliance performs the spinning
phase and drains the water.
• Activate the Extra Silent option.
All spinning phases (intermediate spin
and final spin) are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch the Start/Pauza button: the
appliance performs only the draining
phase.
The appliance empties the
water out automatically after
approximately 18 hours.
6.5 Skvrny/Předpírka
Press this button repeatedly to activate
one of the two options or both.
The relevant indicator goes on in the
display.
• Skvrny
Select this option to pre-treat heavily
soiled or stained laundry using stain
remover.
Pour the stain remover into
compartment
pre-mixed and heated with detergent
in order to improve its effectiveness.
This option can increase
the programme duration.
This option is not
available with a
.
temperature lower than
40 °C.
• Předpírka
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
.
. The stain remover is
Advertisement
Table of Contents
