Table of Contents
Advertisement
EngliSh
SAVE ThESE
inSTRUCTiOnS
CAUTiOn:ThE SYMBOl ShOWn in FigURE 1 MEAnS
-
ThAT ThERE iS A RiSK OF EXPlOSiOn OF ThE
BATTERiES AnD/OR OF SERiOUS DAMAgE TO ThE
BABY MOniTOR iF ThE BATTERiES OR ThE ADAPTER
ARE REPlACED WiTh An inCORRECT TYPE.
Adapter for baby unit:
-
Input: 120 VAC 60 Hz
-
Output: 7.5 VDC 400 mA
-
Adapter no. UD075040B
Adapter for parent unit:
-
Input: 120 VAC 60 Hz
-
Output: 4.5 VDC 400 mA
-
Adapter no. UD045040B
The socket-outlet shall be installed near the equipment and shall be easily
accessible.
For the baby unit, only use 1.5V AA alkaline batteries (batteries not
supplied).
For the parent unit, only use the SCD510 NiMH rechargeable battery pack
as supplied with the appliance.
Dispose of used batteries according to the instructions.
Compliance information
The FCC ID number is located on the casing bottom of the parent unit
and in the battery compartment of the baby unit.
The term 'IC' before the certification number signifies that Industry
Canada technical specifications were met.This certification means that
the equipment meets certain radio communications and operational
requirements. This device complies with Part 15 of the FCC Rules and
ICES-003 of Industry Canada. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation.This device complies also with RSS-213 of
Industry Canada.
Radio interference
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules and
applicable Industry Canada specifications. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
Advertisement
Table of Contents
