Mercedes-Benz CLS 2010 Owner's Manual page 264

Removing the sliding adapter
Remove the mobile phone from its bracket;
X
see the separate mobile phone bracket fit-
ting instructions.
Press both release buttons ; and press
X
sliding adapter : with the mobile phone
bracket upwards until it disengages.
Remove the mobile phone bracket from
X
sliding adapter :; see the separate mobile
phone bracket fitting instructions.
Detach sliding adapter : using suitable
X
tool = and remove.
Garage door opener
Important safety notes
®
The HomeLink remote control integrated in
the rear-view mirror allows you to operate up
to three different door and gate systems.
i
The garage door opener is only available
for certain countries. Observe the legal
requirements in each country.
®
The HomeLink garage door opener is
compatible with most European garage and
gate opener drives. More information on
®
HomeLink and/or compatible products is
available from:
any Mercedes-Benz Service Centre
R
®
the HomeLink hotline
R
(0) 08000 466 354 65 (free of charge) or
+49 (0) 6838 907 277 (charges apply)
on the Internet at: http://
R
www.homelink.com
Programming the integrated garage
door opener in the rear-view mirror
Programming
G
Risk of accident
Only press the transmitter button on the inte-
grated remote control if there are no persons
or objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Integrated garage door opener in the rear-view mir-
ror
Garage door remote control A is not part of
this integrated garage door opener.
i
To achieve the best results, insert new
batteries in garage door remote control
A before programming.
Before programming for the first time, clear
X
the memory of the integrated garage door
opener ( page 263).
Y
Turn the key to position 2 in the ignition
X
lock.
Press and hold one of the transmitter but-
X
tons ; to ? on the integrated garage door
opener.
After a short time, indicator lamp : will
start flashing. It flashes about once per
second.
i
Indicator lamp : flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp : will only start flashing at a rate of
Features
261
Z