Yale KPT-29ZBS Manual

Yale 22132 - KPT-29ZBS Remote Keypad with Tag Reader
Introduction
The Yale KPT-29ZBS is a ZigBee Remote Keypad with Tag Reader. It is designed to have quick access
control of the ZigBee network coordinator or system control panel. Also by assigning User PIN Code to
a Tag, users can use the Tag to gain access control of the system with a simple swipe. The Keypad can
send wireless signals to and receive wireless signals from the coordinator in the ZigBee network. The
LCD display will display any information the ZigBee network coordinator or system control panel sends
back.
The Keypad can either be mounted on a flat surface or wall mounted with the use of the 4 mounting
knockouts. It also has tamper protections switch which will be activated upon any attempt of
unauthorized opening of the cover.
The Keypad utilizes ZigBee technology for wireless signal transmission. ZigBee is a wireless
communication protocol that is reliable and has low power consumption and high transmission efficiency.
Based on the IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a
network and coordinated for data exchange and signal transmission
The Keypad serves as an end device in the ZigBee network. It can be included in the ZigBee network to
transmit signal upon activation, but cannot permit any other ZigBee device to join the network through
the Keypad.
Parts Identification
1. Power LED
- Lights up when the LCD Display is on.
2. Backlit LCD Display
3. Status LED
- Lights up when a fault exists in the system.
4. Backlit Numeric keys
5. Backlit Arm/ Key
6. Backlit Home/ Key
7. Backlit  Key
8. Backlit  Key
9. IR Sensor
10. Backlit # Key
11. Backlit OK Key
- To reset the Remote Keypad:
Press and hold the OK Key for 10
seconds.
Release the button when the LCD display
shows a "KPT will reset in 2 seconds"
message.
12. Cover Open Switch
13. Buzzer
14. Backlit RFID Sensor Zone
1