Troubleshooting; Pairing A Bluetooth Device - ION IPA30B Quick Start Manual

TROUBLESHOOTING

If the sound is distorted: Try lowering the volume control of your sound source or musical instrument. Also, try to
reduce the overall volume of JOB ROCKER.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This
will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback. Point
the microphone away from the speaker.
If there is poor AM reception: When you have a Bluetooth device that is paired, unpair your Bluetooth device in
order to listen to AM radio. To adjust AM reception, move entire unit.
If you ca hear the microphone over the music volume: Turn down the music volume from your source.

PAIRING A BLUETOOTH DEVICE

1. Turn on your Bluetooth device.
2. Power on JOB ROCKER and it will automatically go into pairing mode to search for Bluetooth devices.
You will know you are in pairing mode when the LED is blank.
3. If your Bluetooth device is not able to pair to the amp, press the disconnect button on the amp to
break previous Bluetooth connections and reset the Bluetooth module.
4. Navigate to your Bluetooth device s setup screen, find ION Sp
Note: If your Bluetooth device prompts for a pairing code, enter
5. JOB ROCKER LED will light up solid when it is 'paired'.
Note: Users should consider updating their OS if experiencing trouble with pairing or playing music.
6. To disconnect pairing, press the
7. To connect to another Bluetooth device, repeat steps 3-4.
isconn button on JOB ROCKER.
5
and connect.