Advertisement
3. Pair the HV3400 Wi-Fi control box to the home network with the EWelink app.
a. Provide power to the control box without it being connected to the Ghost fan.
b. Remove the lid to the HV3400 control box to gain access to the EWelink Wi-Fi device.
Use a #1 sized Phillips head screw driver to remove the 4 black screws on the black box lid.
c. Locate the
d. Press the Pairing button on the
every few seconds.
e. On your smart device, open the EWelink app and tap the (+) symbol.
Use the appropriate pairing method for your device as illustrated below
f. Input your Wi-Fi SSID Network name and password.
g. Name the module in the field provided: "ON/OFF"
i. When the EWelink device has connected to the home network successfully the Wi-Fi LED
h. Repeat steps 3c-3g, for the LOW/HIGH module, naming the field "LOW/HIGH"
i. Test functionality with EWelink to confirm the control box is switching (audible clicks).
Factory reset
If any information was entered incorrectly during the set up process, a factory reset is recommended. To
perform a factory reset to the EWelink module press and hold the "Pairing Button" for upwards of seven
seconds until the LED blinks a different pattern. The factory reset is now complete. You may start the pairing
process again (Step 3d).
ON/OFF
receiver module inside of the box.
will remain lit, confirming connection.
ON/OFF
module for 7 seconds until the Wi-Fi LED blinks 3 times
Advertisement
