Panasonic NE-1024F Operating Instructions Manual page 18

r
lif
lo
uJ
z
This oven monitors its operation and displays a Failure Code in the Display Window when a problem occurs.
Whal to do when a failure code appears:
NOTE: Above codes shown in Display Window do not indicate all the possible failures on the unit.
1. Unplug the oven before cleaning.
2. Keep the inside of the oven clean. When food spatters or
spilled liquids adhere to oven walls, wipe with a damp cloth.
N4ild detergent may be used if the oven gets very dirty. The
use of harsh detergent or abrasives is not recommended.
The air intake splash guard/light diffuser can be removed for
cleaning by removing the center plugs from the two plastic
rivets. The top is held by two tabs.
Wash in warm dishwater and replace.
3. The outside oven surfaces should be cleaned with a damp
cloth. To prevent damage to the operating parts inside the
oven, water should not be allowed to seep into the ventilation
openrngs.
4. lf the Control Panel becomes wet, clean with a sott, dry cloth.
Do not use harsh detergents or abrasives on Control Panel.
When cleaning the Control Panel, leave oven door open to
prevent oven from accrdentally lurnrng on.
After cleaning, touch STOP/RESET Pad to clear Display
Window.
5. lf steam accumulates inside or around the outside of the oven
door, wipe wilh a soft cloth. This may occur when the
rnicrowave oven is operated under high humidity conditions
and in no way indicates mallunction of the unit.
6. Clean off grease and dust on bottom surfaces otten. Use
warm detergent solution.
7. Cleaning inside the oven outer panel and inside the oven
base should be performed only by qualified service personnel
after taking precautions to drain all stored voltage potential.
The bottom is accessible by removing the center section of
the base and the power and sensor control areas are within
the outer wrap around housing. Avoid using liquids and
cleaning solutions in these areas. Use a dry sott bristle brush
or a cloth. Reolace all oarts-Do not connect the oven to the
electricity supply il any parts are not reassembled.
C O D E
CAUSE
WHAT TO DO
F01
'Overcooked lood
.Temperature of exhaust air too high.
'Press STOP/RESET Pad to stop beep.
'Wait for oven to cooi down and reset.
'lt a flame is Dresent, do not open oven door.
'lf normal operation does not resume, call the service agent with
information of tailure code.
F33-34
'Defective sensor circuit
. Unplug the oven and wait more than 10
seconds before reconnecting.
'lf normal operation does not resume, cali the
service agent with the information of tailure
code.
F44
'When a pad was pressed for more
than 30 seconds
"Detective pad or control circuit
- 1 8 -