ViewSonic IFP9850-3 User Manual page 98

Button lock
Menu lock
Number
*3.1.1
Key Pad
*3.1.1
Remote
Control
Restore default
NOTE:
1. Behavior at Lock Modes
Lock Mode
Button Lock
MENU Lock
POWER Lock
Remote control
disable
2. Wake-on-LAN by MAC address as alternative for SET Power on
(Length=126 Bytes)
6 Bytes 6 Bytes (#1) 6 Bytes (#2)
0xFF FF ... FF MAC address MAC address
8 s
8 s
8 s
8 s
8 s
8 s
1. Lock all buttons on the front panel and RCU, except for "Power"
2. All the SET functions should be workable via RS32, even the ones with
according hot key in RCU like Mute,...etc.
1. Lock "MENU' key of front panel and RCU
2. The Factory and Hospitality modes should not be blocked for the
model using MENU-combined key to enter these two modes.
Alternative approach will be indicated separately if any limitation by
model.
1. Lock "POWER" key on the front and RCU.
2. The SET_POWER on/off should be workable via RS232, but does not
mean the POWER lock will be released under this case.
3. Can not be unlocked by reset in OSD setting
4. Will auto AC power-on in power-lock
5. Under power-lock, the set will not enter power saving when no PC
signal and neither not turn off when no other video signals after 15
minutes.
Lock the RCU keys, but keep the front panel buttons workable.
8 38 000: Unlock
001: Lock
> 3E 000: Unlock
001: Lock
@ 40 000~009
A 41 000: UP
001: DOWN
002: LEFT
003: RIGHT
004: ENTER
005: INPUT
006: MENU/(EXIT)
007: EXIT
B 42 000: Disable
001: Enable
002: Pass through
~ 7E
Behavior
... 6 Bytes (#16)
... MAC address
98
*See note in details
*See note in details
Disable: RCU will
be no function
Enabled: RCU con-
trols normally
Pass through:
Display will bypass
the RC code to con-
nected device via
the RS232 port, but
not react itself.
000 Recover to factory
setting
24 Bytes
0x00 00 ... 00