Fuses; Tracking; Cutting Height Pedal; Hydro Release Levers - Husqvarna MZ 48 Operator's Manual

CONTROLS

Fuses

Fuses are located on the left hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7,5 A is for the mower deck coupling.

Tracking

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure for the rear tires is 103 kPa (1 bar).
1. Tracking adjustments are made using the
tracking bolt and tracking knob. The tracking
bolt and tracking knob act as limiting devices
for the motion control levers when in the full-
forward position.
2. For preliminary tracking adjustment, move
unit to an open, unobstructed area such as an
empty parking lot or open field.
3. Back the tracking bolt out until flush with nut.
4. Loosen tracking knob out until flush with nut.
5. Test operate unit by driving it at full throttle
and the full forward position on both motion
control levers. Gradually turn in the tracking
bolt on the right hand side until the unit
noticeably starts drifting right.
6. Drive forward at full throttle with both motion
control levers in the full forward position.
Gradually turn in the tracking knob (left side)
until unit tracks straight.

Cutting Height Pedal

The desired cutting height is set with the height
pin. The cutting height pedal releases the deck lift
to place the deck at the selected height.
For transport, push the lift pedal fully forward
until the deck lift latches in the transport (highest)
position.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.

Hydro Release Levers

Transaxle bypass linkages must be engaged
when pushing or pulling the mower. The release
levers are located on each side of the rear of the
unit below the rear engine plate. See Manual
Transport in the Operation section.
WARNING! Bypass linkages are located
close to the muffler. To prevent burns, the
engine should be shut off and allowed to cool
before the bypass linkage levers are handled.
15