Advertisement
6
UPPER CHUTE (See Figs. 6A & 6B)
1. Lower mower to its lowest cutting position.
2. Assemble upper chute by inserting curved end into
hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger
indicator.
3. Push in and turn upper chute until it is in line with lower
chute.
4. Align the bosses on lower chute with alignment slots
on upper chute and slide together.
5. Secure with rubber latch by hooking hole in latch over
latch pin.
UPPER
COVER
CHUTE
FULL BAGGER
INDICATOR
HANDLE
LOWER
CHUTE
FIG. 6A
ALIGNMENT
SLOT
LATCH PIN
RUBBER
LATCH
BOSSES
FIG. 6B
7
INSTALL CROSS BLADES
(See Fig. 7)
New Blade Bolts supplied
The blade mounting bolts provided in this kit must be used
when mounting the cross blades to your mower. Do not
discard the hardware removed from single blade assembly.
The shorter single blade bolt and fl at washer must be used
when con vert ing back to a single blade.
1. Remove blade bolt, lock washer and fl at washer securing
blade.
2. In a safe place, store the blade bolt and fl at washer for
future use when converting back to a single blade.
3. Install cross blade and adapter on bottom of original
blade with new blade mounting bolt provided and lock
washer removed from single blade assembly.
IMPORTANT: To ensure proper assembly, center hole in
original blade must align with star on mandrel assembly.
4. Tighten blade bolt securely.
Store Bolt and Flat
Washer in a safe place
NEW CROSS BLADE
ADAPTER
EXISTING
LOCK WASHER
NEW
BLADE BOLT
8
LEVEL MOWER
•
Be sure mower is properly leveled for best mower
per for man ce. See your tractors owner's manual for
ins truc tions
9
ORIGINAL SINGLE BLADE
LH
FIG. 7
STAR
Advertisement
