Table of Contents
Advertisement
3
.
3
V
i
g
o
r
2
8
6
2
3
.
3
V
i
g
o
r
2
8
6
LED
Status
ACT
Blinking
(Activity)
Off
USB
On
Blinking
WAN2
On
Off
Blinking
DSL
On
Blinking
2.4G/5G
On
Blinking
Line
On
Off
Phone 1/2
On
Off
Blinking
LED on Connector
Left LED
LAN P1~P4
(Green)
Right LED
(Green)
Left LED
P5/ WAN2
(Green)
Right LED
(Green)
The port "P5 / WAN2" is switchable. It can be used for LAN connection or WAN
connection according to the settings configured in WUI.
V
a
c
2
V
a
c
Explanation
The router is powered on and running normally.
The router is powered off.
USB device is connected and ready for use.
The data is transmitting.
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
The router is ready to access Internet through DSL
link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
2.4G/5G: Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and simultaneously when
WPS is working, and will return to normal condition after
two minutes. (You need to setup WPS within 2 minutes.)
A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will be
off.
There is no PSTN phone call.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
On
Off
Blinking
On
Off
On
Off
Blinking
On
Off
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps.
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps.
9
Advertisement
Table of Contents
