GE APFD06 Owner's Manual And Installation Instructions page 5

Controls
The display will always default to show room temperature.
When the air conditioner is turned on, it will automatically start in the last mode and fan settings selected.
Frost Protection Function:
In cooling or dry mode, if the temperature of the exhaust
hose is too low, the AC will automatically go into a
unit protection state. When the temperature rises to a
Overflow Protection Function:
When water in the water pan exceeds the warning level,
the machine will automatically sound an alarm, the FULL
indicator light will flash and the unit will shut down. At
this point, you need to drain the water from the lower
drain (See Drainage instructions for details)
Automatic Defrosting (on some models)
The machine has an automatic defrosting function.
Protection Function of the Compressor
To increase the service life of the compressor, the AC
has a 3-minute delay after the compressor has shut off
Drainage Instructions
Draining the unit manually:
Note: Please move the AC carefully, do not spill the
water in the water pan at the bottom of the unit.
1. When the AC stops after the water is full, turn off the
AC power and unplug the power plug.
2. Place a water container larger than the sump
capacity (at least 1-1/2 quart) below the lower rear
water outlet on the back side of unit.
3. Remove the plug, the water will automatically flow
into the container.
Note: During drainage, the body can be tilted slightly
backwards. If the water container cannot hold all the
water, before the water container is full, replace the water
plug as soon as possible to prevent water from flowing to
the floor or the carpet.
4. After water has been drained from the unit, re-install
the water plug securely.
Note: Restart the AC after the water plug is installed,
otherwise condensate water from the AC will drain onto
the floor or carpet.
Continuous drainage (optional, and only in dry mode)
1. Remove the upper drain plug.
2. Connect a drain hose with an inside diameter of 5/8"
to the water outlet.
3. Route drain hose to a bucket or floor drain.
49-5000527 Rev. 2
normal temperature, the unit will automatically resume
normal operation.
After the water is emptied, the machine the machine will
automatically resume normal operation.
to protect the compressor.
4. Be sure to use a large container (3 gallons or larger
is recommended) and monitor the water level in the
container continuously. The unit will not shut off when
the container is full. An overflowing container can
cause flooding and damage to the floor.
5