Table of Contents
Advertisement
Adjusting the Color Tuner Settings
The Color Tuner settings allow you to adjust the color management system, 2 point
white balance, 11 point white balance, turn color channels off for testing, and display
SMPTE, flat, ramp, and uniformity analyzer test patterns.
WARNING: The Color Tuner, 11 Point White Balance, and test
patterns allow technicians to manually calibrate the TV . Calibration
requires specialized training, an input with precisely set colors, and
a specialized light meter .
To access the color tuner table:
Menu
>
Picture
>
Color Calibration
>
Color Tuner
To turn color channels off and on:
1 .
Use the Navigation buttons on the remote to highlight Red, Green, or Blue .
2 .
Press the OK button to turn the color channel off or on. An X appears over a
color channel that has been turned off.
3 .
Only two color channels can be turned off at the same time.
TIP: Any changes made affect the color temperature setting. Select
the preferred color temperature setting first. See Adjusting the
Color Temperature on page 16.
To adjust the color management system/2 point white balance settings:
1 .
Use the Navigation buttons on the remote to highlight the Hue, Saturation,
Brightness, Offset, or Gain of the color you wish to adjust. Press the OK button .
2 .
Use the Left/Right Navigation buttons to adjust the value . When you are
finished press the OK button to save the setting .
Color Tuner
Red
Green
Blue
Cyan
Hue
0
0
0
0
Saturation
-1
5
-4
0
Brightness
-24
0
-22
0
Offset
0
0
0
Gain
0
0
0
To adjust the 11 Point White Balance settings:
1 .
From the Color Tuner table, use the Navigation buttons to highlight the top bar
and then press the Left/Right Navigation buttons until the 11 POINT WHITE
BALANCE menu is displayed .
11 Point White Balance
Gain
Red
Green
Blue
5%
0
0
2 .
Use the Navigation buttons on the remote to highlight the Gain and Color
values you wish to adjust . Press the OK button and use the Left/Right
Navigation buttons to adjust the value. When you are finished, press the OK
button to save the setting .
To show or hide the SMPTE Test Pattern:
Menu
>
Picture
>
Color Calibration
Pattern
Magenta
Yellow
25
-14
-2
0
1 .
Use the Navigation buttons on the remote to highlight Off . Use the Left/
0
0
Right Navigation buttons to select On to show the SMPTE Pattern .
To hide the SMPTE Test Pattern, use the Left/Right Navigation buttons to
2 .
select Off .
0
3
>
Calibration Tests
>
SMPTE Test
SMPT Test Pattern
Off
—or—
18
Advertisement
Table of Contents
