Changing External Parts (5) Base Unit - Bernina Deco 330 Operation, Service Manual & Parts List

Deco 330

Changing External Parts (5) Base Unit

1
2
4
1
3
1
Base
To remove:
1 Remove the Belt cover. (See page 2)
2 Remove Screws (A)
unit .
3 Disconnect the X Motor
from the printed circuit board (A).
Screws (A)
1
X-motor connector (Blue)
2
Y- motor connector (White)
3
4 Extension table (Accessory)
To attach:
4 Connect the X, Y - Motor Connectors
printed circuit board (A).
5 Insert the X, Y - Motor cords between the printed
cuircuit board (A) and Arm.
Make sure that the cords should not be caught between
the arm and base unit when attaching it, then tighten
1
Screws (4 pieces) temporarily.
6 Attach the Extension (Accessory) table
7 Tighten Screws (A)
table, base unit and free Arm.
8 Attach the belt cover.
5
1
(4 pcs.), and remove the base
2 and Y Motor 3 connectors
2 , 3
.
4
while aligning the extension
1
to the