Page 1
Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. CROWN FOOD SERVICE EQUIPMENT A Middleby Compan 70 Oakdale Road, Downsview (Toronto) Ontario, Canada, M3N 1V9 Telephone: 919-762-1000 www.crownsteamgroup.com...
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 IMPORTANT NOTES FOR INSTALLATION AND OPERATION This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 TABLE OF CONTENTS DESCRIPTION PAGE Important Notes for Installation and Operation ........2 1.0 Service Connections...
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 2.0 INSTALLATION Position appliance on counter allowing sufficient rear clearance from wall to tilt freely and completely without obstruction. Mark four corner locations of appliance base, as shown below.
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 3.0 CLEANING INSTRUCTIONS NOTICE: As a safety precaution disconnect the power supply during cleaning and servicing. The Electric Counter Tilting Skillet should be cleaned after each use. Soak cooking surface with water and a mild soap to remove any food stuck to surface.
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 4.0 OPERATION INSTRUCTIONS Insure that unit has been electrically connected and that circuit breakers are on. Place power switch in “ON” position. Set the thermostat dial to high (#10).
INSTALLATION AND OPERATION MANUAL, ROUND ELECTRIC COUNTER TILTING SKILLET, MODEL ECTRS-16 5.0 TROUBLESHOOTING Unit will not operate: 1. Power supply not “ON”. 2. Defective thermostat or elements. Hot spot on pan bottom: 1. Element not operating. Check for defective element or wire termination.