Panasonic DMP-BDT310 Owner's Manual page 14

When you experience
problems with settings
Wireless Settings
Wireless Settings
Failed to complete.
A conflict with another device occurred.
Do you want to configure wireless network connection
setting again ?
Yes
OK
Display
A conflict with another
device occurred.
A time out error
occurred.
An authentication error
or a time out error
occurred.
A device error occurred.
14
VQT3B58
No
Check the following
≥ Please wait a few moments,
and then try again.
≥ Setting of the Wireless router
for MAC Address etc.
≥ The signal may be weak.
[BDT110] : Using the USB
extension cable supplied with
the Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID (
15) and the
encryption key of the Wireless
router.
≥ Please wait a few moments,
and then try again.
≥ [BDT110] : Connection of
Wireless LAN Adaptor
≥ Contact our Customer
Service Center or your
nearest dealer.
Network Easy Setting
(Home Network Connection Check)
Network Easy Setting (Home Network Connection Check)
Complete.
1. LAN cable connection : Fail
2. IP address setting : Fail
3. Connection to gateway : Fail
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again. Select "No" and press [OK]
to finish Network Easy Setting.
Yes
OK
Display
1. LAN cable connection or
Wireless setting
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Wireless setting
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Wireless setting
2. IP address setting
3. Connection to gateway
Network Easy Setting (Internet Connection Check)
Network Easy Setting (Internet Connection Check)
Complete.
- Connection to the Internet : Fail(Error code: B019)
Failed the connection test.
Cannot find the server.(Error code: B019)
Please refer to the owner's manual for the cause of
the error and the solution for it.
Press [OK].
OK
Display
≥ "Primary DNS" and "Secondary
Cannot find the
server.
(Error code: B019)
≥ The server may be busy or the
Failed to connect to
the server.
(Error code: B020)
≥ Settings of "Proxy Server
No
Check the
following
≥ Connection of
: Fail
the LAN
cables (
: Fail
: Fail
≥ Connection
: Pass
and settings
of the hub
: Fail
and router
: Fail
≥ Settings of
"IP Address/
: Pass
DNS
: Pass or
Settings"
Home
( 32)
network
available
: Fail
Check the following
DNS" settings of "IP Address/
DNS Settings" ( 32)
service may have been
suspended. Please wait a few
moments, and then try again.
Settings" ( 32) and the router
10)