Hilti TE 6-A36 Manual page 18

10.2.2 Drilling with the dust removal module
1. Start the dust removal module by pressing the control button on the rotary hammer drill.
2. Hold down the control button until full suction power is reached.
3. Position the suction head with the edge seated flat against the work surface.
4. Drill the hole and ease the product slowly out of the drilled hole in order to catch as much dust as
possible.
10.2.3 Emptying the dust box
Regular cleaning and emptying are necessary because a full dust box or a clogged filter can lead to
excessive dust formation.
Empty the dust box after drilling 8-10 holes (16 mm x 50 mm) (5/8 in x 2 in).
To minimize dust formation, carefully transfer the dust to a container with a tight-fitting lid.
1. Hold the power tool horizontal and allow it to run for a short time.
▶ This ensures that residual dust deposits in the dust removal module are drawn into the dust box.
2. Press and hold down the release button of the dust box.
3. Pull the dust box down and clear of the dust removal module.
4. Empty the dust box.
▶ Filter is clogged.
▶ Change the filter.
▶ Filter is free of dust.
5. Push the empty dust box back into the dust removal module from below until it engages.
10.2.4 Cleaning the TE-DRS OSHA filter
Clean the filter after drilling 5 holes (16 mm x 50 mm) (1/2 in x 3 in).
▶ When suction power diminishes, slide the cleaning mechanism 5 times forward and back until it audibly
clicks on each slide.
10.2.5 Removing the module
1. Move the forward / reverse switch on the rotary hammer to the middle position.
2. Press the DRS release button and hold it in this position.
3. Pull the dust removal module forwards away from the power tool.
11 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r4694033.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12 English
11
13
12
2100249
*2100249*