ASSEMBLY ..................................6 Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
7. This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
• The product warranty period beings on the purchase date. If the purchase date is unknown, the product warranty period begins on the thirtieth day after shipment from a Datavideo office. • Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.
1xHD/SD-SDI Input Output Interface 8xCVBS, BNC Connector 75Ohms 10 x Cable Ties (120mm) Non Linearity ≤ 1% SD-CVBS Signal 1 x RP-45A Fitting S/N Ratio > 60 dB Instructions Multiburst ≤ 1dB Operating & 0°C to 40°C (32°F to 102°F)
Assembly Use the four rack fixing screws to secure the panel into the rack (MS-2800). RP- 45A: This rack mount rear panel patch is designed to provide up to 8 CVBS outputs by converting a single HD/SD-SDI Video input signal. Use the four rack fixing screws to secure the panel into the rack (OBV-2800).
Page 7
Service & Support It is our goal to make owning and using Datavideo products a satisfying experience. Our support staff is available to assist you to set up and operate your system. Contact your local office for specific support requests. Plus, DATAVIDEO WORLDWIDE OFFICES please visit www.datavideo.com to access our FAQ section.