Table of Contents
Advertisement
Kickstand Replacement Process
Preliminary Requirements
IMPORTANT:
Required Tools and Components
•
Tools:
o
3IP (Torx-Plus) driver
o
Soft ESD safe mat
o
Microfiber cloth
•
Components:
o
Kickstand (Refer to Illustrated Service Parts List)
(Component includes new 3IP screws)
Prerequisite Steps:
•
Power off device – Ensure device is powered off and disconnected from a power supply.
General Safety – Check to make sure that general guidelines and ESD compliance steps are followed prior to
•
opening device. Refer to Prior to Device Disassembly section
Procedure – Removal (Kickstand)
Place device screen-down on soft ESD safe mat. Ensure mat is clear of any abrasive material that may
1.
scratch the Touch Display Module (TDM) glass.
2. Extend the kickstand to approximately 90°
11
Be sure to follow all special (bolded) notes of caution within each process section.
(page
10) for details.
M1192218
Hide quick links:
Advertisement
Table of Contents
