Abit WI-2Pa User Manual page 40

3-14
Use IR Pins
Two options are available: RxD2, TxD2 and IR-Rx2Tx2. The default setting is
IR-Rx2Tx2. If you choose RxD2, TxD2, your workstation board must support a COM
port IR KIT connection. Otherwise, you can only choose the IR-Rx2Tx2 to use the IR
header on your workstation board to connect your IR KIT. Please use the default
setting.
Onboard Parallel Port
This item sets the address of the onboard parallel port.
Parallel Port Mode
This item sets the operation mode of the parallel port. [SPP] (Standard Parallel Port)
allows bi-directional parallel port operation at normal speed; [ECP] (Extended
Capabilities Port) allows bi-directional parallel port operation at a speed faster than
the normal mode's data transfer rate; [EPP] (Enhanced Parallel Port) allows
bi-directional parallel port operation at maximum speed.
EPP Mode Select
This item selects the EPP mode.
ECP Mode Use DMA
Two options are available: 1
for the parallel port mode is ECP, the DMA channel selected can be Channel 1 or
Channel 3.
PWRON After PWR-Fail
This item sets the system action after a power failure.
Game Port Address
This item sets the address of the onboard game port connector.
Midi Port Address
This item sets the address of the onboard midi port connector.
Midi Port IRQ
This item sets the IRQ of the onboard midi port connector. If you choose disable the
Midi Port Address, then this field is not available.
WI-2Pa
3. The default setting is 3. When the mode selected
Chapter 3