General Safety Precautions - Clarke CFP11F Operating & Maintenance Instructions

GENERAL SAFETY PRECAUTIONS

Before using your compressor, read and pay attention to the following safety
guidelines.
1. Make sure that all persons using the compressor have read and fully
understand these operating instructions and had any necessary training
2. Compressed air is dangerous. DO NOT point a jet of air at persons or
animals or discharge compressed air against the skin.
3. Repairs must only be carried out by a qualified engineer. If problems occur,
contact your CLARKE dealer.
4. Before carrying out any maintenance, make sure that the pressure is
released from the air receiver.
5. DO NOT leave pressure in the air receiver overnight or when transporting.
6. DO NOT adjust or tamper with the safety valve. The maximum pressure is
set at the factory.
7. DO NOT operate in wet or damp conditions. Keep the compressor dry at all
times. Similarly, clean air will allow the compressor to work efficiently. Do
not use in dusty or otherwise dirty locations.
8. Some metal parts can become hot during operation. DO NOT touch these
until the compressor has cooled down.
9. ALWAYS set the pressure regulator to the recommended setting for the air
tool being used.
10. When spraying flammable materials e.g. cellulose paint, ensure that there
is sufficient ventilation and keep clear of any source of ignition.
11. DO NOT use this compressor in explosive atmospheres.
12. DO NOT operate this compressor in a confined space unless additional
ventilation is provided.
13. Before spraying any material always consult paint manufacturers
instructions for safety and usage.
14. Wear PPE such as goggles to protect your eyes from flying particles. Face
masks will protect you against paint spray and fumes.
15. This compressor will produce noise levels in excess of 70dB(A). Persons
working near the compressor must be equipped with ear protection.
16. Make sure that air hoses are not kinked or wrapped around the compressor
and not subjected to strain.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
3