Advertisement
Quick Links
How To hardwire the CANON SURE SHOT OWL PF DATE 35mm CAMERA
This document outlines the modification of the Canon Sure
Shot Owl PF Date Camera so the shutter controls can be
operated remotely. It is recommended that the following "three
wire" setup be used in all cameras modified, and alternate "2
wire" setups are converted outside the camera.
Please note that following these modifications will void the
camera's warranty. No guarantee is implied or expressed in
these instructions. This is my way of modifying the Canon Sure
Shot Owl PF Date Camera and modifications have worked to
my satisfaction. Alternate modification methods are recognized
as valid alternatives.
#1 Remove the Screws
The first step is to remove the screws from the camera body. There are 7 screws that need to be
removed. #0 Philips Screwdriver is recommend for screw removal.
Remove screws next to battery door
Remove screws from side
Revised 1/12/04
Remove screw on back
Remove screw from door latch side
Advertisement
Related Manuals for Canon Digital Camera
Summary of Contents for Canon Digital Camera
- Page 1 How To hardwire the CANON SURE SHOT OWL PF DATE 35mm CAMERA This document outlines the modification of the Canon Sure Shot Owl PF Date Camera so the shutter controls can be operated remotely. It is recommended that the following “three wire”...
- Page 2 Remove screw inside camera enclosure #2 Remove Viewfinder Shroud, Battery Door, and Shutter Button Assembly Remove viewfinder shroud by prying shroud away from camera body at the top corner. Remove shutter button assembly. Viewfinder shroud removed from camera body. Remove battery door.
- Page 3 #3 Remove the Camera Body from the Camera Cover Remove the camera body from the camera cover by prying the body from the battery compartment. The camera body can be removed completely from the camera cover. The camera body removed from the camera cover. Camera body / cover.
- Page 4 #4 Modify Wire Route and Attach Wiring Harness Locate camera body side with strap guide. Notch the strap guide for the wire route. Insert wires through lower hole in camera cover, and hot glue “free” end into strap guide slot.
- Page 5 #5 Wiring the Camera Wire the camera with the following positions. One wire is soldered to the pad that connects to pin 6, (counted from right to left) on the top pc board of the camera. This is the refresh wire. One wire is soldered to the pad that connects to pin 5, (counted from right to left) on the top pc board of the camera.
- Page 6 Better picture of solder pad 4 (common) #6 Reassemble Camera Body and Cover Slide camera body into camera cover inserting right side of camera body first. Press camera body into camera cover, until the door latch hits edge of camera body.
- Page 7 Pry camera cover over door latch and slide camera body back into camera cover. Check fit at bottom of camera cover. Check fit on top of camera cover Check wiring harness to make sure wires are not located directly under top screw hole.
- Page 8 #7 Reinstall Shutter Button Assembly, Battery Door, and Viewfinder Shroud. Reinstall shutter button assembly, battery door, and viewfinder shroud that were removed in step #8 Reinstall Screws Reinstall screws, starting with the longest screws at the strap guide holes. Squeeze camera body and camera cover together for these screws only.
- Page 9 #9 Finish Hardwired Camera and Testing Complete wired camera with “three wire” setup, showing servo three wire connector. To test camera, refresh wire #6 and shutter wire #5 are solder together. Camera will fire flash when these two wires are touched to common wire #4. Camera must be on, and back door must be latched.