Gigabyte T1000 Series User Manual page 31

Hide thumbs Also See for T1000 Series:
Table of Contents

Advertisement

WARNING: Please pay attention to the following information about
keyboard maintenance.
1.Dust build-up may occur to the keyboard after long-term use.
It is recommended to clean the keyboard with a small brush.
Please shut down the machine before cleaning the surface of
the keyboard and wipe it with a soft cloth dipped in cleaner or
water gently.
2.In case any liquid enters the keyboard, shut off the power
supply immediately, remove the batteries and contact the
original manufacturer directly for repair. Do not disassemble the
keyboard yourself for repair.
Hard Disc Drive (HDD)
Trouble
The operating system is corrupted by incorrect
operation or virus. Try to clean virus and then
HDD can't be
configure your operating system correctly.
booted
Maybe the documents of your OS run in error;
please refer to the manual of your OS.
There is too much file fragment. Use disk
HDD performs very
defrag tools to rearrange the programs on the
slowly
hard disk.
WARNING: Please pay attention to the following information about
Hard Drive maintenance.
1.The hard disk is a high-speed data storage device. Avoid using
the T1000/T1005 in unstable locations as far as possible to
prevent hard disk damage and data loss.
2.Please use the computer in accordance with normal startup/
shutdown procedures; improper startup/shutdown may shorten
the service life of the hard disk.
Solution
Printer
Trouble
Make sure printer is powered on.
Make sure its cable is OK and its USB interface
The data can't be
is well connected to T1000/T1005.
output from T1000/
T1005 to printer
Make sure your printer is compatible to your
T1000/T1005.
Please refer to the user's manual of your
Error printing
printer for help.
LAN
Trouble
Be sure the RJ45 connector is firmly connected
Can't be connected
to the Network Hub or Switch.
USB
Trouble
Check if the Netbook module name is T1000/
T1005M. The USB3.0 port (positioned at the
left side of T1000/T1005M) embedded with
Equipments
T1000/T1005M can't work under DOS mode.
connected can't
Please connect the USB cord of the equipment
work
to other USB ports.
Be sure the driver of the equipment is installed
correctly.
T1000 SERIES USER'S MANUAL
Solution
Solution
Solution
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

T1005 series

Table of Contents