BEC430 INSTRUCTION MANUAL Nespresso is an exclusive system creating the ultimate Espresso, time after time. All Nespresso machines are equipped with a unique extraction system that guarantees up to 19 bar pressure. Each parameter has been calculated with great precision to ensure that all the aromas from each capsule can be extracted, to give the coffee body and create an exceptionally thick and smooth crema.
SAFETY PRECAUTIONS for indoor and non-extreme persons with reduced physical, the voltage of the power source is temperature conditions use only. sensory or mental capabilities, or the same as that specified on the CAUTION: the safety • Protect the appliance from direct whose experience or knowledge rating plate.
Page 4
SAFETY PRECAUTIONS ovens, gas burners, open flame, or openings. Doing so may cause fire or • Never use an already used, damaged Nespresso coffee capsules available similar. electrical shock! or deformed capsule. exclusively through the Nespresso • Always place it on a horizontal, stable •...
OVERVIEW Packaging content 1 Drip tray 8 Water tank lid 2 Drip grid + cup support 9 Water tank 3 Capsule container for 9 – 11 used capsules Coffee machine 4 Coffee outlet 5 Lever 6 Espresso button (small cup) 7 Lungo button (large cup) Nespresso capsule tasting gift Welcome...
FIRST USE First read the safety precautions to avoid risks of fatal electrical shock and fire Remove the plastic film from the drip grid. Remove the water tank and capsule container. Insert the remaining cable in the cable guide Plug the machine into the mains. Adjust the cable length and store the excess under the machine and put the machine in the under the machine.
Never lift lever during operation and refer to the safety precautions to avoid possible harm when operating the appliance During heat up, you can press the coffee button For a Latte Macchiato glass fold the cup support Take the cup. Lift and close the lever to eject the Press the Espresso (40 ml) or the Lungo when it’s still blinking.
PROGRAMMING THE WATER VOLUME Fill the water tank and insert the capsule. Press and hold the Espresso or Lungo button. Release the button once the desired volume is Water volume level is now stored. served. EMPTYING THE SYSTEM BEFORE A PERIOD OF NON-USE, FOR FROST PROTECTION OR BEFORE A REPAIR To enter the emptying mode, press both Remove the water tank.
RESET TO FACTORY SETTINGS CLEANING Factory settings: Espresso cup: 40 ml, Lungo cup: 110 ml; Auto Off mode: 9 mins. Do not use any strong cleaning agent or solvent cleaner. Do not put in a dishwasher. LEDs will blink fast 3 times to confirm machine has been reset Never immerse the appliance or to factory settings.
Page 10
Switch the machine on. Blinking light: heating up. Steady light: ready. Press both coffee buttons simultaneously for Press the Lungo button and wait until the water three seconds. They will start blinking. tank is empty. Refill the water tank with the used descaling Empty and rinse the water tank.
TROUBLESHOOTING SPECIFICATIONS No light. ➔ The machine has switched off automatically; turn the machine on. 220-240 V, 50-60 Hz, <1260 W ➔ Check the mains: plug, voltage, fuse. 19 bar No coffee, no water. ➔ Check the water tank, if empty, fill with fresh potable water. Descale it if necessary. ➔...
Breville authorised service agent. Contact Nespresso Australia: 1800 623 033 or New Zealand: 0800 234 579 auclub@nespresso.com This product is imported and distributed by Breville and this warranty is provided by Breville. To the extent permitted by law, Nespresso has no liability for the product and all guarantees, warranties and conditions by Nespresso are excluded.