Power On Self Test Messages - Fujitsu Lifebook V1020 User Manual

Power On Self Test Messages

The following is an alphabetic list of error-and-status messages that Phoenix BIOS and/or your
operating system can generate and an explanation of each message. Error messages are marked with an
*. If an error message is displayed that is not in this list, write it down and check your operating system
documentation both on screen and in the manual. If you can find no reference to the message and its
meaning is not clear, contact your support representative for assistance.
nnnn Memory Cache Passed
Where nnnn is the amount of system cache in kilobytes successfully tested by the Power On Self
Test. (This can only appear if you have an SRAM PC Card installed.)
*Extended Memory Failed at address line: xx
Extended memory not working or not configured properly. If you have installed a memory upgrade
module, verify that it is properly installed. If it is properly installed, check your Windows Setup to be
sure it is not using unavailable memory until you can contact your support representative.
nnnn Extended RAM Passed
Where nnnn is the amount of memory in kilobytes successfully tested.
*Failure Fixed Disk n (where x=1-4)
The fixed disk is not working or not configured properly. This may mean that the hard drive type
identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the
setup utility to check for the hard drive type settings and correct them if necessary. If the settings are
OK and the message appears when you restart the system, there may be a serious fault which might
cause you to lose data if you continue. Contact your support representative.
*Incorrect Drive A type – run SETUP
Type of floppy drive A: not correctly identified in Setup. This means that the floppy disk drive type
identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the
setup utility to correct the inconsistency.
92 - Troubleshooting