Network Settings - Panasonic Viera TC-P60S30 Owner's Manual

This is a setting for connecting to a broadband environment.
■
Press to exit from
a menu screen
■
Press to go back to
the previous screen
Connection test
Check that the Network settings are as shown below, and then start "Connection test".
Select "Connection test" and press OK
(It takes a while to cancel the test.)
Displayed Connection test screen
Connection test
Check Ethernet cable connection
Validate IP address
Check for IP address duplication
Check connection to the Internet
Check communication with EASY IPTV server.
Test in progress...
Network connection
Select Network type (Ethernet cable/Wireless (WiFi))
Wireless network (Confirm Current settings and status)
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
■
Displayed "Current settings and status" screen (If connected with wireless LAN adapter)
You can confirm the AP connection status.
(SSID/Wireless type/Security type/Encryption type/Connection status /Signal strength)
Press "Wireless network"
Wireless network
SSID :
Wireless type :
Security type:
Encryption type :
Connection status :
Signal strength :
Connect using these settings?
Yes No
(example)
36

Network settings

Display the menu
Select "Network settings"
Menu
Setup
Channel surf mode
All
Language
Clock
ANT/Cable setup
Input labels
Anti image retention
Network settings
VIERA Link settings
Select the settings and set
Menu
Network settings
Connection test
Wireless (WiFi)
Network connection
Wireless network
IP address/DNS settings
Network cameras list
Software update
00-0b-97-7c-65-e9
Mac address
select
OK
select
1/2
select
adjust
Complete Connection test
Success-->Completion screen is displayed.
Error-->Follow the directions on screen to complete the setting.
If you perform the Proxy settings, check the Proxy address
and the Proxy port number.
When you change "Wireless network" -->Press "No"
See "Sets / Changes wireless network setting" on p. 37
and follow the directions on screen to complete the
setting.
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".