Table of Contents
Advertisement
Problem
The built-in
Your application has locked out
keyboard does not
your keyboard.
seem to work.
(continued)
You have installed an
Your external device is not prop-
external keyboard or
erly installed.
mouse, and it does
The operating system software is
not seem to work.
not set up with the correct soft-
ware driver for that device.
You have connected
Your operating system
an external keyboard
software is not setup with
or a mouse and it
the correct software driver
seems to be locking
for that device.
up the system.
When the system is
This happens due to the design
slightly inclined and
specifications of the Quick Point
the QuickPoint
device.
device has been
worked with slowly
for several seconds,
the cursor slowly
moves across the
screen when you are
not using it.
Memory Problems
Your Power On
Your memory upgrade module is
screen, or Main menu
not properly installed.
of the BIOS setup
utility information,
You have a memory failure.
does not show the
correct amount of
installed memory.
Modem Problems
Messages about
Messages about modem opera-
modem operation.
tion are generated by whichever
modem program is in use.
USB Device Problems
You have installed a
The device is not properly
USB device but your
installed.
LifeBook notebook
The device may have been
does not recognize
installed while an application
the device, or the
was running, so your notebook is
device does not seem
not aware of its installation.
to work properly.
Your software may not have the
correct software driver active.
You may have the wrong I/O
address selected for your device.
Possible Cause
T r o u b l e s h o o t i n g
Possible Solutions
Try to use your integrated pointing device to restart
your system. If this fails, turn your system off using the
Power Off button located on the back of the system.
Wait 10 seconds or more, then turn the system back on.
Re-install your device. (See Device Ports on page 35 for
more information)
Check your device and operating system docu-menta-
tion and activate the proper driver.
Check your device and operating system documentation
and activate the proper driver.
If this occurs, wait until the cursor stops moving; it
should then work properly.
Remove and re-install your memory upgrade module.
(See Memory Upgrade Module on page 35 for more infor-
mation)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 47 for more
information)
See your application software documentation for addi-
tional information.
Remove and re-install the device. (See Device Ports on
page 35 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software documen-
tation to determine the required I/O address. Change
the settings in the BIOS setup utility. (See BIOS Setup
Utility on page 23 for more information)
41
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
