Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Fujitsu Manuals
  4. Laptop
  5. P1610 - LifeBook - Core Solo 1.2 GHz
  6. Technical procedure

Fujitsu LifeBook P1610 Technical Procedure

Bluetooth board replacement
Hide thumbs Also See for LifeBook P1610:
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
LifeBook P1610
Bluetooth Board Replacement
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.

Advertisement

loading

Related Manuals for Fujitsu LifeBook P1610

Summary of Contents for Fujitsu LifeBook P1610

  • Page 1 LifeBook P1610 Bluetooth Board Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Extract these 3 screws from the remove the battery Hard Disk Drive cover and lift it off.
  • Page 2 5. Extract 11 screws from the lower 6. Extract 2 screws from the rear of case. the LifeBook. 7. Open the LifeBook and lay it flat. 8. Use a plastic pry tool to remove the keyboard upper trim. 9. Lift the top edge of the keyboard 10.
  • Page 3 13. Turn the Display back and lay it 14. Disconnect 2 Display cables from down. the system board and the 2 antenna cables from the WLAN Card. 15. Extract 2 screws from the Display 16. Lift the Display off the lower hinge.
  • Page 4 21. Extract 1 screw from the 22. Transfer the ribbon cable from Bluetooth board and lift it out. the defective board, insert the new one and secure it with 1 screw. 23. Connect the Bluetooth ribbon 24. Place the upper case and cable, the Bluetooth antenna cable connect the ClickPoint button cable and the IO Board ribbon cable.
  • Page 5 29. Tilt the display up and rotate it ¼ 30. Slide the lower hinge cover into turn place. 31. Turn the Display back and lay it 32. Plug in the cables for the down. keyboard and ClickPoint. 33. Turn the keyboard over and slide 34.
  • Page 6 37. Insert 11 screws into the lower 38. Insert the Hard Drive. case. 39. Press the latch down to lock the 40. Replace the Drive cover and cable into place. secure it with 3 screws. 41. Replace the battery.