Fujitsu Lifebook E335 Manual page 84

S e c t i o n F o u r
Routinely Entering the Setup Utility
You can enter the setup utility whenever you
turn on or reset the system. To do this:
1. Allow the system to start booting.
2. As soon as the Fujitsu logo appears on the
screen, press the F2 key.
3. The Main menu of the setup utility then
appears with the current settings of the
parameters displayed.
4. If you wish to go to one of the other setup
menus, press the or the key to find the
menu you require.
P O I N T
If your data security settings require it,
you may be asked for a password before
the Main menu will appear.
70
Entering the Setup Utility After a
Configuration Change or System Failure
If there has been a change in the system config-
uration that does not agree with the parameter
settings stored in your BIOS memory, or there
is a failure in the system, the system beeps
and/or displays an error message after the
Power On Self Test (POST). If the failure is
not too severe, it will give you the opportunity
to modify the settings of the setup utility, as
described in the following steps:
1. When you turn on or restart the computer
there is a beep and/or the following message
appears on the screen:
Error message - please run
SETUP program
Press <F1> key to continue,
<F2> to run SETUP
2. If an error message is displayed on the
screen, and you want to continue with the
boot process and start the operating system
anyway, press the F1 key.
C A U T I O N
If your notebook beeps a series of
beeps that sounds like a code and
the display is blank, please refer to
the Troubleshooting Section. The
Troubleshooting Section includes
a list of error messages and their
meanings. (See pages 151-169.)
P O I N T
If your data security settings require it,
you may be asked for a password before
the operating system will be opened.