Fujitsu Lifebook E335 Manual page 34

S e c t i o n T w o
P O I N T
If you reject the terms of the license
agreement you will be asked to review
the license agreement for information on
returning Windows 98 or to shut down
your notebook.
Product Key
Look in the box that your notebook came in
and you will find a Windows 98 Certificate of
Authenticity shrink wrapped with the Windows
98 Users manual. On the certificate you will
find a bar-code with a number above it. This is
your product key and the number you should
enter on the Product Key screen. When you
have entered the number exactly as shown then
click on the Next> button.
Start Wizard
The Start Wizard screen will appear if you have
entered a valid product key. When you click on
the Finish button the display will flash various
screens as the system identifies what hardware
is installed.
20
Time Zone
When your notebook has completely identified
all of the installed hardware it will display a
dialog box for entering which time zone you
wish to set the clock to.
Printer Setup
When the time zone setup is complete a dialog
box will appear for selecting which printer is to
be attached to your notebook. You do not have
to select a printer at this time. If you do not
wish to select a printer, click on the Cancel
button. If you do wish to select a printer click
on the Next button and answer the questions.
Welcome to Windows 98
When you boot into Windows 98 for the first
time you will see a Welcome to Windows 98
dialog box with several options. Select the first
option, Register Now, to register your LifeBook
E Series notebook. (See page 21 in this section
for details on registering your notebook in
Windows 98.)
Booting the System with Windows NT 4.0
We strongly recommend that you not attach
any other external devices and do not put any
CD or floppy disk in your drives until you have
gone through the initial power on sequence.
When you turn on your notebook for the first
time it will display a Fujitsu logo on the screen.
If you do nothing the system will read the hard
drive for the operating system software, flash
the notebook configuration information on the
screen, and then the Windows NT 4.0 Setup
Wizard Screen will appear. You will then be
stepped through the condition of use process.
You must complete this initial process before
you will be able to use your notebook. (If you
wish to access the BIOS setup utility before you
go through the condition of use process you
must press the F2 key while the Fujitsu logo is
still visible. If you press the Esc key while the
Fujitsu logo is still present you will get a dialog
box which will allow you to select which drive is
to be used for finding the operating system.) If
you turn off the power without using the on
screen Cancel button you will get an error
message when you start your notebook again.