L i f e B o o k C S e r i e s – S e c t i o n F o u r
CHECKING THE COMPUTER RECOGNITION
OF NEW MEMORY CAPACITY
Once you have changed the system memory capacity
by either adding or removing a memory upgrade
module, be sure to check that your notebook has
recognized the change.
You can check the memory capacity by looking at the
main menu of the BIOS setup:
1. Turn on the power to your notebook using the
power switch.
2. Allow the system to start booting and press the key
once the Fujitsu logo appears on the screen. This will
open the main menu of the BIOS setup with the
current settings displayed. (See BIOS Setup Utility on
page 35 for more information)
The System Memory and the Extended Memory
capacity, as detected by your notebook during the Power
On Self Test (POST), are displayed at the bottom of the
main menu screen. The chart below shows you the
possible displays that can be shown on the main menu
screen.
58
P O I N T
If the total memory displayed is incorrect, check that
your memory upgrade module is properly installed. (If
the module is properly installed and the capacity is still
not correctly recognized, see the Troubleshooting sec-
tion starting on page 65)
Installed
On Board
Slot 1
Total RAM
Installed
64MB
0
64MB
64MB
32MB
96MB
64MB
64MB
128MB
64MB
128MB
192MB
Displayed
System
Extended
Memory
Memory
640K
63MB
640K
95MB
640K
127MB
640K
191MB