Fujitsu Lifebook A3040 Software Manual page 6

L i f e B o o k A S e r i e s B I O S
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options
LBA Mode Disabled
Control:
Enabled
Transfer Mode: Standard
Fast PIO 1
Fast PIO 2
Fast PIO 3
Fast PIO 4
Fast PIO 3/DMA
Fast PIO 4/DMA
Ultra DMA Mode: Disabled
Mode 0
Mode 1
Mode 2
Mode 3
Mode 4
C A U T I O N
A bootable CD-ROM may have either a floppy disk for-
mat or a hard drive format. When the bootable CD-
ROM is used, the drive allocations change automatically
without changing the BIOS setup. If a floppy disk for-
mat CD-ROM is used, the CD-ROM becomes Drive A.
The CD-ROM will only take drive C: (hard drive format)
if the internal hard drive is not present or is disabled.
The bootable CD-ROM can never use a C: designation
if a formatted internal hard drive is present, since the C:
designator is always reserved for the internal hard
drive.The boot sequence ignores the new drive designa-
tions; however, your application software will use the
new designations.
6
Default Description
[Enabled] Enables or disables Logical Block Addressing in place of Cylinder,
Head, Sector addressing. This option cannot be changed when
Auto is selected.
[Fast PI0 4] Selects the method for moving data to/from the drive. Autotype
the drive to select the optimum transfer mode. This option cannot
be changed when Auto is selected.
[Mode 2] Selects the method for moving data to/from the drive. Autotype
the drive to select the optimum transfer mode. This option cannot
be changed when Auto is selected.
Be careful of the operating environment when booting
from a CD-ROM or you may overwrite files by mistake.
Exiting from Main Menu
When you have finished setting the parameters on this
menu, you can either exit from the setup utility, or move
to another menu. If you wish to exit from the setup
utility, press the [Esc] key or use the cursor keys to go to
the Exit menu. If you wish to move to another menu, use
the cursor keys.
C A U T I O N