Setting the refresh rate for your external monitor
The refresh rate must be correctly set so that the image does not flicker.
►
Select the monitor type in the menu Start - (Settings) - Control Panel - Appearance and Themes -
Display - Settings - Advanced - Display.
►
Now select the Adapter tab.
►
Adjust the refresh rate and then click Apply.
If the refresh rate set is too high, the monitor may be damaged. Please see the
!
documentation included with your monitor for the maximum possible refresh rate.
Connecting USB devices
On the USB ports you can connect external devices that also have a USB port (e.g. a printer, a
scanner or a modem).
USB devices are hot-pluggable. This means you can connect and disconnect devices
i
while your operating system is running.
USB 1.x has a maximum data transfer rate of 12 Mbit / s.
USB 2.x has a data transfer rate of up to 480 Mbit/s.
Additional information can be found in the documentation for the USB devices.
►
Connect the data cable to the external device.
►
Connect the data cable to a USB port of the notebook.
Device drivers
i
Some USB devices will be automatically recognised and installed by your operating
system. However, newer devices will need to be installed using the supplied CD / DVD.
Always follow the instructions supplied with the device to complete the installation.
USB disk drives
Various USB disk drives are supported by your notebook.
i
Fujitsu Siemens Computers recommends use of the following devices:
●
USB Floppy Disk Drive - Fujitsu CP078730-03 (YE-DATA)
●
USB Floppy Disk Drive - TEAC FD-05PUB
10600664372, edition 2
Connecting external devices
49