Westinghouse WVES613L User Manual page 41

Oven
PROBLEM
Oven or grill
not working
The oven seal is loose
Oven light
not working
Oven not heating enough
Clock flashing
on display
Unit smoking
when first used
Condensation
build up
Door cannot be replaced
after removal
Functions and temperature
appear on display but oven does
not work
When the door is open the fan
stops (underbench only)
When a non fan mode is selected
the fan starts
The light stays on when the door
is closed
The light does not turn *ON*
when the door is opened
Shelf or telescopic runner slides
out when door is opened
NOTE: Only authorised personnel should carry out servicing.
POSSIBLE CAUSE
• Time of day not set.
• Power not turned on.
• Controls are incorrectly set.
• Oven is in 'Demo' mode, refer to Using your oven section.
• Household fuse has blown or power supply is off.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Child-proof oven lock is activated. 'LOCKED' is displayed when control is
touched. (Refer to Using your oven section)
• The oven seal is only attached at each corner. It may seem like a loose fit but
when the oven door is closed it will function correctly.
• Light may be turned off at control panel.
• Lamp blown or loose in socket.
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Foil or trays on bottom of oven.
• Timer is in "AUTO" mode. (Refer to timer operating instructions)
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Reset time of day and any cooking functions you were using.
• Protective oils being removed.
• Reduce the amount of water used in cooking. (Sometimes condensation is
normal)
• Stirrup not engaged properly.
• Oven is in 'Demo' mode, refer to Using your oven section.
• This is a function of the power board to help reduce the blast of air when
opening the door.
• Most oven modes have a fast heat up function that uses the fan, fan element
and top (boost) elements. Auto fast heat up can be overridden by selecting a
temperature of 120°C or less, allowing the function to start, then increasing the
temperature to the desired level.
• An oven function has been selected.
• The light has been turned on at the control panel.
• Oven light may need replacing.
Oven cavity is not level, you can perform a check using a level to verify this
(refer to installation section). If not level refer to installer.
41
TROUBLESHOOTING