Kohler Command PRO CV732 Service Manual page 64

Reassembly
Install External Governor Controls
1. Install governor lever onto governor cross shaft.
2. Connect choke linkage into bushing/lever from back.
Make certain that control shaft offset is back.
Connect throttle linkage and spring to governor
lever.
3. Move governor lever toward carburetor as far as it
will go (wide-open throttle) and hold in position.
4. Insert a long thin rod or tool into hole on cross shaft
and rotate shaft counterclockwise (viewed from end)
as far as it will turn, then torque nut to 6.8 N·m
(60 in. lb.).
5. Connect governor spring from throttle control lever to
appropriate hole in governor lever. Connect
governed idle spring from governed idle bracket to
G-hole in governor lever. Refer to Governor Lever
and Hole Position/RPM Chart. Note that hole
positions are counted from pivot point of governor
lever.
Governor Lever Hole Position
B
C
D
E
F
A Governor Lever
C Hole 1
E Hole 3
64
A
B Governed Idle Hole
D Hole 2
F Hole 4
KohlerEngines.com
Governor Lever and Hole Position/RPM Chart
(Governed Idle, 10% Regulation)
High Idle Governor Lever
RPM Hole No.
4200
4000
3950
3900
3850
3800
3750
3700
3650
3600
3550
3500
3450
3400
3350
3300
Install Electric Starter Motor
1. Install starter motor using screws. Position lift
bracket to also secure dipstick tube.
2. Torque screws to 15.3 N·m (135 in. lb.).
3. Connect leads to solenoid.
4. Install dipstick tube and align mounting hole with
threaded hole in lift bracket. Secure with M5 screw.
Torque screw to 4.0 N·m (35 in. lb.).
Governor
Spring Color
Code
4 Black
3 Purple
3 Purple
3 Green
3 Green
3 Red
3 Red
2 Green
2 Green
2 Red
2 Red
2 Clear
2 Clear
2 Clear
2 Clear
2 Clear
24 690 37 Rev. B