Table of Contents
Advertisement
Chapter
2
Preparation
2
Thank you
Your new TV has many features and incorporates the latest technology to enhance your viewing
experience. We recommend that you spend some time reading this instruction manual so that you fully
understand these features. You will also find some hints and tips to help you resolve any issues.
Read all the safety instructions carefully before use and keep this instruction manual for future reference.
Unpacking the TV
Remove all packaging from the TV. Retain the packaging. If you dispose of it please do so according to local regulations.
The following items are included:
TV
GB
Instruction Manual
32" HD-Ready LED TV with DVD
LT-32C345A / LT-32C346A
Instruction Manual
LT-32C345_46A_IB.indd 7
for purchasing your new JVC TV.
Quick Start Guide
32" HD-Ready LED TV
with DVD
LT-32C345A / LT-32C346A
Thank you
for purchasing your new JVC TV.
Your new TV incorporates the latest technology to enhance your viewing
experience. We would suggest that you allow about 20 mins for initial setup.
Please follow this guide for a successful first time installation.
The latest eco-friendly power-saving technology will switch off the TV if
device is left on and idle for 4 hours. Please refer to "Auto Standby" under
the "Time Settings" section of the instruction manual for more detail.
1
Unpacking
Remove all packaging from the unit. Retain the packaging.
If you dispose of it please do so according to any local regulations.
TV
Screws x 4
TV Stand
Instruction Manual
Remote Control/
Quick Start Guide
AAA Batteries x2
3
Installing the Base Stand
1. Ensure the TV is switched off and not connected to
the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge
of a table so the base of the TV slightly overhangs
the edge of the table, with the back side facing up.
Please make sure a soft cushioned material (such as
a dry bath towel or thick piece of foam) is placed
beneath the screen.
3. Slide the stand under the lip, the neck will fit snuggly
over the screw holes. Then screw the stand to the TV
using the 4 screws supplied.
Cushioned
material
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that no hard or sharp object,
or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure on the front of the TV at any time because
the screen could crack.
LT-32C345_46A QSG.indd 1
Quick Start Guide
Stand screws x4
TV Stand
4
Connecting the Aerial and Turning on the TV
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the
other end of the cable to the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the
button on the remote control to turn the TV on.
The red LED indicator will flash for a few seconds then the TV will switch on.
VGA
SPDIF
SCART
RF coaxial cable
(not included)
• Do not connect the TV to the mains supply until you have completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove the mains plug from the mains socket.
5
Tuning in the TV
1. The first time you turn the TV on, it will go
6. Confirm these settings by pressing OK.
Choose Region
straight into the First Time Installation
7. Press the
buttons to highlight Home
During tuning, your TV may have received
menu. Please ensure the aerial is plugged in.
Mode then press OK.
Press the
buttons to highlight your
signals from more than one transmitter. If this
language then press OK.
has occurred the Choose Region screen will be
displayed. This will enable you to select the
correct regional transmission for the local news
First time installation
service that you require.
Welcome please select your language!
English
If the TV is to be used in a store, please select the Store Mode. For domestic use,
Home Mode is recommended.
button to highlight Primary
Bienvenue ! Veuillez choisir une langue.
Francais
1. Press the
Willkommen, Wahlen Sie bitte lhre Sprache aus!
Deutsch
region, then press the
buttons to select
Benvenuti, Selezionate la vostra lingua!
Italiano
Home Mode
Store Mode
Bienvenido, seleccione un idioma
Espanol
your Primary Region e.g. England.
Hos geldiniz, lutfen dil secimini yapiniz!
Turkce
2
Operating Your Remote Control
Dobrodosli, izberite vas jezik!
Slovenski
Valkommen, valj ditt sprak!
Svenska
Udvozoljuk, kerjuk valassza ki a nyelvet!
Magyar
Automatic channel scan (Retune)
Bem-vendo, favor selectionar seu idioma
Portugues
Choose region
Tervetuloa, valitse kielesi!
Suomi
Please wait. This will take a few minutes. Scanning digital channels: UHF 22
Multiple regional variants have been detected.
1. Open the battery
Select Language
OK
Set Language
Cambs & Beds: BBC TWO HD
Please choose your preferred region.
compartment on the back
8. You will now be asked if you want to start
Cambs & Beds: Channel 4 HD
the automatic channel scan. Press the
Cambs & Beds: BBC ONE HD
Country
UK
of the remote control.
Primary region
Any
2. Press the
buttons to select your country.
buttons to highlight Yes and press OK.
Cambs & Beds: ITV HD
Cambs & Beds: BBC THREE HD
Secondary region
Any
2. Insert two AAA size
Cambs & Beds: CBBC HD
Tertiary region
Any
batteries. Make sure to
First time installation
Channels Found :
6
OK
match the (+) and ( - ) ends
Welcome!
MENU
Cancel scan
of the batteries with the
Country
<
UK
>
(+) and ( - ) ends indicated
Search Type
Digital only
2. Press the
button to highlight Secondary
Teletext Language
West
Do you want to start an automatic
in the battery compartment.
channel
region, then press the
buttons to select
Scan Encrypted Channels
Yes
your Secondary Region e.g. London.
3. Replace the battery
Yes
No
compartment cover. Make sure it clicks into place.
3. Press the
button to highlight Tertiary
Please ensure your aerial is plugged in before tuning in your TV
region, then press the
buttons to select
Select Language
Choose your country
OK
OK
Start search
your Tertiary Region e.g. Greater London.
4. Press the
button to highlight OK then
3. Press the
button to highlight Search Type,
Automatic channel scan (Retune)
press OK. Your TV is now fully tuned in.
then press the
buttons to select Digital
Please wait. This will take a few minutes. Scanning digital channels: UHF 22
5. The Edit Channel list will appear, press the
Only. This will only search for the digital
Cambs & Beds: BBC TWO HD
EXIT button to remove this. Your TV is now
channels.
Cambs & Beds: Channel 4 HD
Cambs & Beds: BBC ONE HD
fully tuned in and ready to use.
4. Press the
button to highlight Teletext
Cambs & Beds: ITV HD
Cambs & Beds: BBC THREE HD
Language, then press the
buttons to
Cambs & Beds: CBBC HD
Edit Channel List
select your language. The majority of people
1. BBC ONE Lon
DTV
TV
will want this set to West.
Channels Found :
6
2. BBC TWO
DTV
TV
3. ITV
DTV
TV
MENU
Cancel scan
4. Channel 4
DTV
TV
5. Press the
button to highlight Scan
5. Channel 5
DTV
TV
6. ITV2
DTV
TV
Encrypted Channel (pay-per-view channels),
7. BBC THREE
DTV
TV
then press the
buttons to select Yes
9. BBC FOUR
DTV
TV
or No.
10. ITV3
DTV
TV
Slide under
OK
Move
Delete
Edit name
Lock
Slide under
the lip
Function
Navigate
Filter
OK
Watch
the lip
MENU
Cancel scan
RET.BACK
Back
0....9
Jump
P+
P-
Page UP/DOWN
Table
Well done,
your new TV is now ready to use. You will find that there are many exciting features available. To get to know all these features, please take
some time to read the instruction manual provided with your TV.
(QSG-LT-32C345/46A-140923V1)
23/09/2014 16:22
SOURCE
Remote Control /
AAA Batteries x 2
7
25/09/2014 11:26
Advertisement
Table of Contents
