Table of Contents
Advertisement
HomeWhiz on/off
Press the remotestart key to enable
the function.
Product indicator when the function is
enabled.
If you press the remote start key while
the function is enabled, the Home
Whiz function will be disabled, and the
product indicator will return to the delay
time/programme time display. In the off
position, the HomeWhiz key LED will
go off.
C
You can check the indicator
on the product to see if
wireless connection is
enabled or not.
If the wireless connection is
off, you can see that the Wi-
Fi icon is off.
If the Wi-Fi icon is on, this
means that the wireless
connection of the product
is on and the product is
connected to the wireless
network. If the Wi-Fi icon
is continuously flashing at
regular intervals, this means
that it is enabled but could
not connect or is trying to
connect the network.
Wireless connection is on / off When
the machine is on, press the "Menu"
key for 1 second to enter the settings
menu. Follow the screen and press
<- and +> keys on the panel, then wait
until the Wi-Fi connection indicator
comes on. Press the selection key
and if the Wi-Fi connection is on,
turn it off; if it is off, turn it on. In the
wireless connection on/off settings
menu, if the wireless connection is
on, the Wi-Fi connection indicator will
light permanently; if it is off, the Wi-Fi
connection indicator will flash at short
intervals.
Once the wireless connection has been
turned "On", your machine will connect
to the home network by using the setup
settings you made before.
Deleting the HomeWhiz settings
While the dishwasher is on, press the
"Menu" key for 1 second to enter the
settings menu. Follow the screen and
press <- and +> keys on the panel,
then proceed until the Wi-Fi setting
indicator comes on. Press and hold the
selection key for 5 seconds. After the 5
- 4 - 3 - 2 - 1 countdown on the display,
your settings will be deleted.
HomeWhiz troubleshooting
Follow these instructions if you
encounter a control or connection
problem. If it persists, take the next
step.
1. Check if your smart device is
connected to the internet.
2. Close the HomeWhiz application
on your smart device and start it
again.
3. Restart your smart device.
4. Check the wireless connection
status of your dishwasher. If
you see "WLAN: Off", switch it
to "WLAN: On" and wait for the
machine to connect. Then close
the HomeWhiz application on your
smart device and start it again.
5. If the connection cannot be
established following the
instructions above, repeat the initial
setup settings on the appliance.
6. If the problem persists, contact the
authorised service.
26
USA
Advertisement
Table of Contents
