LG CineBeam PF610P-SA Owner's Manual page 135

90
Network Connection Problems
You can check the network connection status as shown below.
• (Q. Settings)
[Wired Connection (Ethernet)]
• (Q. Settings)
[Wi-Fi Connection]
•
Check the projector or the AP (Router).
• Check the connection status of the projector, AP (Router) and Cable Modem.
•
Power off and power on in the following order;
1. The Cable Modem, wait for the Cable Modem to reset.
2. The AP (Router), wait for the AP (Router) to reset.
3. The projector.
• If you want to establish a wired LAN connection check whether an IP address
can be obtained from your router properly. If you are setting up your network
manually check whether all settings are correct.
• If you want to establish a wireless connection check the following points as well.
1. Set your router's SSID (network name) or wireless channel.
2. Set your router's security key.
If you do not know this setting, check the router's instruction manual and the
manual provided by the Internet provider. If you are still not sure, contact the
router company or the Internet company.
• If you are using a wireless connection, change the SSID (Network name) and
wireless channel of AP (Router).
•
If you are using a static IP, enter the IP directly.
• Contact internet service provider or AP (Router) companies.
[Connection]
[Connection]
[Advanced Wi-Fi Settings]
When X appears next to projector
[Network Connection Settings]
[Network Connection Settings]