Operation Instructions - Dyna-Glo DGW1904BDP-D-1 Manual

ASSEMBLY INSTRUCTIONS
13. Slide the grease cup (I) onto the grease cup
support of the smoker body (G) bottom.
Repeat on the other side.
14. Remove the igniter cap by turning it counter-clockwise.
Insert the AAA battery (U) into the igniter body with
positive (+) end facing out. Replace the igniter cap.

OPERATION INSTRUCTIONS

CONNECTING THE LP TANK
WARNING! ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE FOLLOWED
TO PREVENT FIRE, DAMAGE AND/OR INJURY.
1. The knob on the LP tank must be closed. Make sure that the knob is turned clockwise
to a full stop. The cylinder supply system must be arranged for vapor withdrawal.
2. Check that the control knob on the control unit is turned off.
3. Remove the protective cap from the LP tank valve and coupling nut.
4. Hold the regulator in one hand and insert the nipple into the valve outlet. Be sure the nipple
is centered in the valve outlet. The coupling connects to the large outside threads on the
valve outlet. Use care – do not cross thread the connection.
5. Hand tighten the coupling clockwise until it
comes to a full stop.Firmly tighten by hand only.
Do not use tools.
CAUTION: In the connection
process, make sure the regulator
inlet connector mates with the
cylinder valve outlet properly,
safely and firmly.
13
14
U
14
G
I
Straight