Table of Contents
Advertisement
I cannot dial
Make sure there is a dial
out.
tone before dialing. It is
normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone.
Wait an extra second
before dialing.
Eliminate any
background noise.
Mute the handset
before dialing, or dial
from another room in
your home with less
background noise.
The display
The handset is
deregistered from the
shows To
telephone base.
register HS...
and ...see
Place the handset in
manual
the telephone base
alternately. The
to register it back.
handset does
The handset shows
not work at all.
Registered and you
hear a beep when the
registration process
completes. This process
takes about 90 seconds
to complete.
The display
Place the handset in
shows Low
the telephone base or
charger for charging.
battery.
The battery
Make sure the handset is
does not
placed in the telephone
charge in the
base or charger correctly.
handset or the
If the battery is
handset battery
completely depleted,
does not
charge the battery for at
accept charge.
least 30 minutes before
use.
You may need to
purchase a new battery.
The telephone
Make sure the ringer
does not ring
volume is not set to off.
when there is
The handset may be too
an incoming
far from the telephone
call.
base. Move it closer to
the telephone base.
My handset
Move the handset closer
beeps and is
to the telephone base. It
not performing
may be out of range.
normally.
I hear other
calls when
using the
telephone.
I hear noise on
the cordless
handset and
the keys do not
work.
There is
interference
during a
telephone
conversation.
My calls fade
out when
I am using
the cordless
handset.
45
Disconnect the telephone
base from the telephone
wall jack. Plug in a different
telephone. If you still hear
other calls, the problem is
probably in the wiring or
telephone service. Contact
your telephone service
provider.
Make sure the telephone
line cord is plugged in
securely.
The handset may be out
of range. Move it closer
to the telephone base.
If you subscribe to high-
speed Internet service
(DSL - digital subscriber
line) through your
telephone line, you must
install a DSL filter between
the telephone line cord
and the telephone wall
jack. The filter prevents
noise and caller ID
problems caused by DSL
interference. Contact your
DSL service provider for
more information about
DSL filters.
Appliances or other
cordless telephones
plugged into the
same circuit as the
telephone base can
cause interference. Try
moving the appliance
or telephone base to
another outlet.
The location of your
telephone base can
impact the performance
of your cordless phone.
For better reception,
install the telephone base
in a centralized location
within your home or
office, away from walls
or other obstructions.
In many environments,
elevating the telephone
base improves overall
performance.
Advertisement
Table of Contents
