Table of Contents
Advertisement
Registering and Restoring a
Setup (Registration)
You can use the registration function to register the setup of
the Digital Piano (tone, rhythm, and other settings). You can
recall a registered setup as required to perform a particular
song, etc.
• Registration can be used in the Rhythm Mode (page
EN-30).
• The registration function cannot be used while in the Song
Bank Mode (page EN-26), during demo play (page EN-11),
while in the Music Preset Mode (page EN-37), or while
configuring function settings (page EN-45).
■ Setup Storage Locations
Setup registrations are stored in memory locations that are
divided into eight banks. Each bank has four storage areas,
which means you can register up to 32 setups (8 banks ×
4 areas).
• Use the bt BANK button to specify a bank.
• Specify an area using the ck Area 1 to Area 4 buttons.
Area 1
Bank 1
Setup 1-1
Bank 2
Setup 2-1
.
.
Bank 8
Setup 8-1
■ Registration Memory Data
• Rhythm number
• Synchro start
• Accomp (on, off)
• Keyboard volume
• Accompaniment volume
• Chord input mode
• Split point
• Tone numbers (Upper1, Upper2, Lower)
• Layer (on, off)
• Split (on, off)
• Octave shift
• Duet setting (on, off, octave shift, pan)
• Tempo
• Auto Harmonize (on, off, type)
• Arpeggiator setting (on, off, type)
• Arpeggiator hold (on, off)
• Transpose
• Scale
• Touch Response
• Reverb (on, off, type)
• Chorus (on, off, type)
• Pitch bend range
• Pedal effect
EN-38
...
Area 4
...
Setup 1-4
...
Setup 2-4
.
.
.
.
...
Setup 8-4
■ Saving to an External Device
Setups saved using registration can be saved to a USB flash
drive in bank units. See
"USB Flash Drive
EN-51).
Saving a Setup to Registration
Memory
1.
Press br RHYTHM.
2.
Configure the tone, rhythm, and other settings
you can to include in the setup.
3.
Press bt BANK to select the bank you want.
Each press of bt BANK cycles through the bank
numbers.
• You also can select a bank using the bo dial within
three seconds after pressing the bt BANK button.
4.
While holding down cl STORE, press the
button of the area (ck Area 1 to Area 4) where
you want to save the registration.
This will save the settings you configured in step 2 into
the applicable setup.
• If there is anything already stored in the setup, it will be
replaced (deleted) by the new setup.
S t o r e
Stored in Setup 4-1
Operations" (page
Bank number
Bank 4
Advertisement
Table of Contents
