Table of Contents
Advertisement
Toe Grille Assembly
Instructions
NOTE: If your refrigerator has the type of Mounting
Clips shown in Figure 1B below, use this procedure.
Tools Required: None
To Attach the Toe Grille to the Mounting Clips:
• With the end of the Toe Grille against the side of the
Lower Hinge, align the two (2) Assembly Slots with the
two (2) Mounting Clips.
• Snap the Toe Grille onto the Mounting Clips. (See
Figures 1A and 1B)
NOTE: A properly mounted Toe Grille should have its edge
against the Lower Hinge, and the back of the Toe Grille tight
against the refrigerator base.
To Remove the Toe Grille:
• Carefully tilt the bottom edge of the Toe Grille away from
the refrigerator base.
• Pull the Toe Grille toward you until it "unsnaps" from the
Mounting Clips. (See Figure 2)
For Cleaning:
Hand wash in Warm Soapy Water.
The Toe Grille and Mounting Clips are NOT
dishwasher safe. Placing them in the dishwasher will
result in a warped and unusable Grille.
Figure 1A
Figure 1B
Figure 2
NOTE: If your refrigerator has the type of Mounting
Clips shown in Figure 2 below, use this procedure.
Tools Required: None
To Attach the Toe Grille:
• Open the refrigerator door.
• Line up the Toe Grille Assembly over the two large holes
on the front of the refrigerator base (See Figure 1).
• Push the Toe Grille Assembly into the holes until the grille
snaps in place (See Figure 1).
NOTE (some models): If your refrigerator has a left hand
door swing, the Toe Grille Buttons must be positioned on
the left side of the keyhole slots (See Figure 2).
NOTE: Both Toe Grille Buttons must be mounted on the
same side of the two keyhole slots.
NOTE: The Toe Grille should be flush with the side of the
refrigerator and not interfere with the Lower Hinge.
To Remove the Toe Grille:
• Grasp the Toe Grille on each side and pull directly
outward.
• The grille assembly will pop out of the holes for easy
cleaning.
For Cleaning:
Hand wash in Warm Soapy Water.
13
Figure 1
Figure 2
Advertisement
Table of Contents
