Prestige APS-687TWE Owner's Manual page 12

circumstance will the system allow a transmitter button to be pro-
grammed into 2 receiver channels at the same time.
This remote has the ability to operate 2 Prestige Alarms From A Single
Transmitter. To toggle on and off vehicle one or two,,,
Press the Trunk/Key button + the Lock button for 5 seconds.
The LED flashes 2 times. Release the buttons, to select 2nd vehicle mode.
Program this transmitter into the second vehicle's system. Any time you
are in 2nd vehicle when the transmitter is operated, the LED will flash twice
for each function. When in in the prime vehicle mode, the LED will flash
once for each function.
Transmitter Battery Replacement
1) Remove the 00 Phillips head screw from the rear case.
2) Separate the case halves by inserting a small plastic tool in the top right slot.
3) Carefully slide the CR2032 from the 155SP, or the two 2025's for the 15BER-
15SP battery or batteries out from under the battery clip and dispose of properly.
4) Insert fresh batteries with the (+) side up away from the PCB.
5) Close the case in reverse of disassembly.
FUNCTION SETTING CHART
To be completed by installer:
Door Lock Timer  1 Sec.
Parking Lights  Steady
Run Time  ___________Minutes
Accy Lock  On
Accy Unlock  Dr. Door
NOTE: Two step unlock is an option and may not have been installed.
To purchase replacement transmitters
or to get additional product information go to:
www.prestigecarsecurity.com
©2015 Voxx Electronics Corp., 150 Marcus Blvd. Hauppauge, N.Y. 11788
 3.5 Sec.  1 Sec/Dbl 1 Sec.
 Pulsed
 Off
 All Doors  Off
Page 12
1289446
128-9446
12 of 12