Table of Contents
Advertisement
Projecting
STANDBY indicator
LAMP/COVER
TEMP/FAN
STANDBY
LIGHT
+
VOLUME
4
–
PATTERN
APA
V
B
b
v
RESET
APA key
22
(EN)
5
4, 6
ON indicator
POWER
SAVING
ON
2
I / u
3
INPUT
MENU
ENTER
1
After all equipment is connected completely, plug the AC power cord
into the wall outlet.
The STANDBY indicator lights in red and the projector goes into the
standby mode.
2
Press the I / u key on the Remote Commander or on the control panel.
The ON indicator lights in green.
3
Turn on equipment connected to the projector. Press the INPUT key on
the Remote Commander or on the control panel to select the input
source.
INPUT A: Selects audio and video signals input from the INPUT A
INPUT B: Selects audio and video signals input from the INPUT B
VIDEO: Selects audio and video signals input from the AUDIO IN/
S VIDEO: Selects audio and video signals input from the AUDIO IN/
Note
The AUDIO IN jacks are used as audio outputs of both VIDEO and S
VIDEO.
Note on the VPL-X1000E model
The optional IFB-X600E Interface Board is required for selecting
VIDEO.
COMMAND
I / u
OFF
ON
MUTING
INPUT
AUDIO
PICTURE
APA
APA key
MENU
LASER
V
B
b
ENTER
R CLICK
v
RESET
VOLUME
+
–
connector.
connector.
VIDEO (VIDEO IN) jacks.
S VIDEO (VIDEO IN) jacks.
Rear remote control detector
1
Front remote control detector
2
3
Advertisement
Table of Contents
