Assembly And Adjustments - DeWalt DCD735 Original Instructions Manual

Englis h
intended use
These drills/drivers/hammerdrills are designed
for professional drilling, percussion drilling and
screwdriving applications.
Do Not use under wet conditions or in presence of
flammable liquids or gases.
These drills/drivers/hammerdrills are professional
power tools.
Do Not let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double
e
insulated in accordance with IEC 60335;
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
using an extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable
completely.

assemBly and adjustments

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
10
inserting and removing the
Battery pack from the tool (figure 2)
NotE: For best results, make sure your battery
pack is fully charged.
to install tHe Battery paCk into tHe tool Handle
1. Align the battery pack (j) with the rails inside the
2. Slide it into the handle until the battery pack is
to remove tHe Battery paCk from tHe tool
1. Press the battery release button (k) and firmly
2. Insert battery pack into the charger as
variable speed trigger switch
(figure 1)
To turn the tool on, squeeze the trigger switch (a).
To turn the tool off, release the trigger switch. Your
tool is equipped with a brake. The chuck will stop as
soon as the trigger switch is fully released.
NotE: Continuous use in variable speed range is
not recommended. It may damage the switch and
should be avoided.
forward/reverse Control Button
(figure 1)
A forward/reverse control button (b) determines the
direction of the tool and also serves as a lock-off
button.
To select forward rotation, release the trigger switch
and depress the forward/reverse control button on
the right side of the tool.
To select reverse, depress the forward/reverse
control button on the left side of the tool.
The center position of the control button locks
the tool in the off position. When changing the
position of the control button, be sure the trigger is
released.
NotE: The first time the tool is run after changing
the direction of rotation, you may hear a click on
start up. This is normal and does not indicate a
problem.
WALT battery
e
tool's handle (figure 2).
firmly seated in the tool and ensure that it does
not disengage.
pull the battery pack out of the tool handle.
described in the charger section of this manual.