Download Print this page

Ariens 51121600 Instruction Sheet page 8

Advertisement

ADJUST WHEEL DRIVE CONTROL
All Models
1. See Figure 15.
2. The unit should stop immediately when the wheel
drive control lever is released and not creep
forward when the wheel drive control lever is
disengaged with the engine running.
3. The unit's forward speed should increase as the
wheel drive control lever is moved closer to the
handlebar. If the unit does not accelerate smoothly
or seems to slip under load, adjust the wheel drive
control cable.
IMPORTANT: DO NOT adjust the cable so the
transmission does not return to neutral and stop the unit
when the wheel drive control is released.
To Adjust:
1. Stop engine and wait for all moving parts to
completely stop.
2. Clean any dirt or debris from the drive components.
3. Make sure the return spring is properly connected
to transmission bracket.
4. On the handlebar, loosen cable nuts away from
bracket. See Figure 29.
5. Move the wheel drive cable adjuster up or down the
handlebar. See Figure 29.
To increase speed, move the cable adjuster down
the handlebar.
To decrease speed, move the cable adjuster up
the handlebar.
Razor Fig 29
2
1. Cable Adjuster
2. Cable Nuts
6. Check the adjustment.
A. Start the engine.
B. Slowly squeeze the wheel drive control lever
against the handlebar. The unit should move
forward smoothly and increase in speed as
handle is moved closer to handlebar.
C. Release the wheel drive control lever. The unit
should stop immediately and not creep forward.
CHECK OPERATOR PRESENCE CONTROL /
BLADE BRAKE CLUTCH (OPC / BBC)
HANDLE
Models 911176, 911177
The blade must stop within 3 seconds after releasing
OPC / BBC handle. If the blade does not stop, adjust as
necessary or inspect and repair before using.
Figure 15
08401009 • 2/15 • Page 8 of 8
1

Advertisement

loading

This manual is also suitable for:

511217005112180051122300