Installation; Before You Begin - Delta PCS100 Installation Manual

Installation

This chapter describes how to mount and install the PCS, including the information about
recommended tools, groundwork preparation, location and ventilation considerations, unpacking,
moving and mounting. Read this chapter and plan your PCS layout and installation accordingly.

Before You Begin

Recommended Tools
The following tools are recommended for a successful installation:
 1 x PH2*100 mm Phillips screwdriver
 1 x PH3*100 mm Phillips screwdriver
 1 x M8 hex bolt socket wrench
 1 x M16 hex bolt socket wrench
 1 x M6 hex bolt socket wrench
 1 x M6 Allen wrench
 Concrete drill
 1 x 24-inch adjustable wrench

Hydraulic crimping tools (capable to crimp cable lugs)
 Wire cutter
 Wire stripper
 Diagonal pliers
Grounding Instructions
WARNING!
!
Grounding: All input and output circuits are isolated from the enclosure. System grounding, when
required by EN 62477-1, is the responsibility of the installer.
An equipment grounding conductor or a grounded, metal, and permanent wiring system is required for
the PCS connection. This should be run with circuit conductors and connected to the equipment
grounding bar or lead on the PCS.
Installation Manual 7
Installation