Advertisement
Side Armor with Steps Installation:
FIG
Put on safety glasses. Locate the 4 holes
along the factory pinch weld of your
vehicle as show in picture. (FIG 1)
FIG 3
Install the 6mm hex head bolts through
the pinch weld and the mounting
bracket with washers on both sides and
secure with a 6mm nylock nut using
a 10mm hex wrench and a 10mm
socket. (FIG 3)
FIG 2
Starting at the front of the vehicle
position the mounting tabs of the rock
rails behind the pinch weld and align
the holes with the factory pinch weld
holes as shown. (FIG 2)
FIG 4
Do not fully tighten at this time. Repeat
on the 3 remaining holes. (FIG 4)
The Trusted Source
4
Advertisement
