Advertisement
Quick Links
Quadratec
QRC
®
Side Armor with Step
Installation Manual for 4 Door '18- Current Wrangler JL Vehicles
#
12004.3214
Full Hardware Shown
Side Armor with Step
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUC-
TIONS AND PROCEDURE NOTI ES BEFORE ATTEMPTING TO
INSTALL OR USE THIS PRODUCT. FOLLOW ALL INSTRUCTIONS
AND WARNINGS WITH PRODUCT & VEHICLE OWNERS MANUAL.
THIS PRODUCT IS INTENDED TO REDUCE RISK OF OFF-ROAD
BODY PANEL DAMAGE AND ASSIST IN ENTRY/EXIT FROM
VEHICLE. YOUR TUBE STEP IS NOT INTENDED TO INCREASE
OCCUPANT PROTECTION OR REDUCE VEHICLE DAMAGE IN
EVENT OF ACCIDENT.
PROPERLY TORQUE AND RECHECK FASTENERS AND SECURITY
OF STEP TREAD AFTER 250 MILES AND FREQUENTLY THERE-
AFTER. INSPECT AND DO NOT USE AS A STEP IF DAMAGED.
DO NOT USE ROCKER GUARDS AS A WINCH/SELF-RECOVERY
ATTACHMENT POINT.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING
PERMITTED ON-ROAD EQUIPMENT.
The Trusted Source
Advertisement
Related Manuals for Quadratec QRC
Summary of Contents for Quadratec QRC
- Page 1 Quadratec ® Side Armor with Step Installation Manual for 4 Door ’18- Current Wrangler JL Vehicles 12004.3214 Full Hardware Shown Side Armor with Step TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE: READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUC- TIONS AND PROCEDURE NOTI ES BEFORE ATTEMPTING TO INSTALL OR USE THIS PRODUCT.
- Page 2 Careful attention is required to this instruction or operation but does generally not relate to personal injury. Damage to your Quadratec ® product or other property may result if you don’t follow instructions.
- Page 3 QTY 12 10mm & 16mm Wrenches YOU CAN IDENTIFY THE LEFT AND RIGHT HAND PIECES BY LOCATING THE QUADRATEC LOGO. THE LOGO SHOULD BE AT THE FRONT OF EACH SIDE. YOU MUST REMOVE ANY FACTORY INSTALLED “ROCK RAILS”, SIDE STEPS OR RUNNING BOARDS BEFORE INSTALLATION OF YOUR NEW SIDE ARMOR GUARDS.
- Page 4 Side Armor with Steps Installation: FIG 2 Put on safety glasses. Locate the 4 holes Starting at the front of the vehicle along the factory pinch weld of your position the mounting tabs of the rock vehicle as show in picture. (FIG 1) rails behind the pinch weld and align the holes with the factory pinch weld holes as shown.
- Page 5 Side Armor with Steps Installation: FIG 6 Locate the 3 vertical threaded holes (FIG 6) Then, holding the rocker up behind the pinch weld. Align the holes on center with the pin weld holes fully in the brackets with these holes. (FIG 5) tighten the 6mm hardware.
- Page 6 Completed Installation: The Trusted Source...
- Page 7 Product Care and Maintenance: Your Side Armor with Steps have been For any required touch ups, we recom- designed and manufactured to provide mend using a textured black spray paint years of use. However, like any product, sprayed on a piece of cardboard and general maintenance is required to keep cotton swab to gently fill in these chips.
- Page 8 Quadratec to obtain a RGA number only to Quadratec branded accessories first sold (610-701-3336). All labor, removal, shipping in the United States, Quadratec warrants to the and installation costs are customer’s initial retail purchaser only that your responsibility.