Installing The Antenna; Installing The Belt Clip; Installing The Hand Strap - Kenwood TK-278G Instruction Manual

Installing the Antenna

Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and
turning it clockwise until
secure.
Note: An antenna is not provided
for K market models. It must be
purchased separately.

Installing the Belt Clip

If necessary, attach the belt
clip using the two supplied
3 x 8 mm screws.
Note: If the belt clip is not installed,
its mounting location may get hot
during continuous transmission or
when left sitting in a hot
environment.

Installing the Hand Strap

1 Attach the hand strap
bracket using the two
supplied 3 x 8 mm
screws.
2 Loop the hand strap
through the center hole
of the hand strap
bracket.
Note: If desired, you can install the
hand strap bracket over the belt clip.
5